-
All Categories
-
Clock Movements
-
Watchmaker Tool & Workshop Need
-
Clocks and watches
-
Crafting and designing
-
Batteries
-
Jewelry parts
-
Nose piercing
-
Watch spare parts
-
Clock parts
-
Watch glasses
-
Watch movements by brands
-
Watch Straps and accessories
-
Wristwatches and pocket watches
-
Alarm clocks and large clocks
- Tools/supplies
-
3Dmensionals
-
Weather instruments
-
Craft & creative
-
Expert knowledge & literature
-
Household, security, outdoor
-
Special items
-
Catalogues
-
Clock Movements
BenchMate ring holder
GRS Index ring holder set
€204.99*
The GRS ID ring holder redefines holding of rings. By tightening the clamping axle, the clamping sleeve is pressed into the clamping cones on both sides. This creates uniform pressure and spreads the clamping sleeve evenly. This holds the ring securely on the inside. When using the standard cone, the tension can be adjusted so that the ring can rotate easily during engraving. In contrast, the clamping cone locks the clamping sleeve so that the
ring is held in a fixed position. This allows for secure stone setting. The ring holder is a good, affordable choice if you are looking for a simple, functional, and high-quality solution.
Includes: (1) ID ring holder, (2) sets of 10 pieces each of clamping sleeves, (2) standard cones, (2) cones with special toothing, (1) clamping axle, (1) retaining nut, (1) hex nut, and (1) GRS Allen wrench.
Clamping sleeve diameter:
13.5 mm, 14.5 mm, 15.5 mm, 16.5 mm, 17.5 mm,
18.5 mm, 19.5 mm, 20.5 mm, 21.5 mm, 22.5 mm
Pictured in the assembled state with 18.5 mm
clamping sleeve and standard cone.